09612-50010 WASHER, DRIVE SHAF Denso Cross


Rating:
46
Buy WASHER, DRIVE SHAF 09612-50010 genuine, new aftermarket engine parts with delivery

Information washer, drive shaf Denso

Cross reference number



Part num
Firm num
Firm
Name
09612-50010 
22161-5401 
WASHER, DRIVE SHAF
0961250010 
22161-54010 
TOYOTA
WASHER, DRIVE SHAF
0961250010 
22161-54010 
TOYOTA
WASHER, DRIVE SHAF
0961250010 
8-97140930-0 
ISUZU
WASHER, DRIVE SHAF
0961250010 
ME736337 
MITSUBISHI
WASHER, DRIVE SHAF
0961250010 
S501 24 036 
MAZDA
WASHER, DRIVE SHAF




Information:

General Hazard Information
Tampering with the 3176 system installation or the truck OEM wiring installation can be dangerous and could result in personal injury or death and/or engine damage.The use of high powered or illegal radio transmitter equipment in a 3176 equipped vehicle may interfere with proper operation of the 3176 system. Properly installed and functioning auxiliary equipment such as CB radios, high output FM stereos, radar detectors, etc. should not prevent proper operation of the 3176 system.The 3176 uses high voltage to the unit injectors. Do not come in contact with the injector terminals while the engine is running. Attach a "DO NOT OPERATE" or similar warning tag to start switch or controls before servicing or repairing the truck engine. These tags, Form SEHS7332, are available from your Caterpillar dealer.Do not allow unauthorized personnel in the truck when it is being serviced.When operating the engine in a closed area, vent the exhaust to the outside.If the engine is not running, do not release the secondary or parking brake systems unless the truck is blocked or restrained.Wear a hard hat, protective glasses and other protective equipment as required by job conditions.Do not wear loose clothing or jewelry that can catch on controls or other parts of the engine.Make certain all protective guards and covers are secured in place.Use all cleaning solutions with care.Never put maintenance fluids into glass containers since glass containers can break.Report all needed repairs.* Stop the engine.* Ensure the protective locks or controls are in the applied position.* Apply the secondary (emergency) and parking brakes.* Block or restrain the vehicle before servicing.* Disconnect the batteries before servicing the electrical system.* Do not attempt repairs you do not understand.* Use proper tools and replace or repair broken or damaged equipment.* When starting an engine after repairs have been made to the fuel system, make provisions for shutting off the engine's intake air supply, (to stop the engine), in case there is an overspeed on start-up.* Start the engine only from the operator's station. Never short across the starter terminals or the batteries as this could bypass the engine neutral-start system as well as damage the electrical system.Pressure Air and Water
Pressure air can cause personal injury. When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 30 psi (205 kPa) for cleaning purposes.Wear eye protection at all times when cleaning the cooling system. Pressurized water could cause debris and/or hot water to be blown and result in personal injury.Fluid Penetration
Always use a board or cardboard when checking for a leak. Escaping fluid under pressure, even a pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury immediately.Asbestos Information
Caution should be used to avoid breathing dust that may be generated when handling components containing asbestos fibers. If this dust is inhaled, it can be hazardous

Have questions with 09612-50010?





Group cross 09612-50010

Back to top