09180-00600 TIMER ASSY, AUTOMA Denso Cross

1. Remove circlip (1) and the washer from each end of the rocker shaft. 2. Put identification marks on the rocker arms, brackets and springs as to their location on the rocker shaft. Remove rocker arms (2), brackets (3) and springs (4) from each side of the rocker shaft.3. Remove screw (5) and rocker shaft oil feed connection (6). 4. Remove nut (7) and adjusting screw (8) from the rocker arm.5. Measure the bore of the bearings in each of the rocker arms. The bore must be 19.06 to 19.10 mm (.7505 to .7520 in.).6. Measure the diameter of the rocker shaft at each of the rocker arm locations. The diameter must be 19.01 to 19.04 mm (.7485 to .7495 in.). The maximum permissible clearance between the rocker arm bearings and shaft is 0.13 mm (.005 in.).7. If a replacement is needed, remove bushing (9) with tooling (A) and a press.Assemble Rocker Shaft
1. If a replacement was needed, make an alignment of oil hole (1) in the bushing with the oil hole in the rocker arm. Install new bushing (3) in the rocker arm with tooling (A) and a press. Check the bore dimension of the bushing in the rocker arm after installation. It must be 19.06 to 19.10 mm (.7505 to .7520 in.).
Do not turn the adjusting screw too far into the rocker arms. Damage to the valve can be the result after the rocker shaft and push rods have been installed in the engine.
2. Install adjusting screw (4) and nut (2) in the rocker arm. 3. Slide oil feed connection (9) on the rocker shaft. Install bolt (5) that holds it in place.4. Install springs (6), brackets (7) and rocker arms (8) in their original positions. 5. Install washer (11) and circlip (10) on each end of the rocker shaft.End By:a. install rocker shaft and push rods