Rating:
Information shim Denso
Include in ##:
Cross reference number
Part num
Firm num
Firm
Name
09133-10270
SHIM
Information:
Above 0°C (32°F)
Consult the Operation (Operator's) Guide for "Before Starting" checks. 1. Move transmission range selector (1) to NEUTRAL and lock (2) to ON. 2. Move all scraper hydraulic controls to HOLD. 3. Apply the parking brake. 4. Move the cushion hitch control to LOCKDOWN. 5. Insert the key and turn the battery disconnect switch ON.
Never turn the disconnect switch OFF when the engine is running.
6. To prevent engine overspeed at startup, be sure the throttle lock button is OUT. 7. Push the accelerator pedal to just past the engine stopped detent. 8. Push in and TURN the start switch to START. Release the switch when the engine starts.
After every 30 seconds of cranking, allow 2 minutes for the starting motor to cool.
9. If the engine oil pressure gauge does not register within 10 seconds, stop the engine by pulling up on the accelerator pedal. Have corrections made.10. Keep the engine at low idle until the systems are warm.11. Watch all gauges and indicators. They must have correct readings before moving the machine.Below 0°C (32°F)
1. Follow the steps under "Above 0°C (32°F)."
If the engine does not start after two attempts, use starting fluid. This will prevent excessive battery drain and starting
Consult the Operation (Operator's) Guide for "Before Starting" checks. 1. Move transmission range selector (1) to NEUTRAL and lock (2) to ON. 2. Move all scraper hydraulic controls to HOLD. 3. Apply the parking brake. 4. Move the cushion hitch control to LOCKDOWN. 5. Insert the key and turn the battery disconnect switch ON.
Never turn the disconnect switch OFF when the engine is running.
6. To prevent engine overspeed at startup, be sure the throttle lock button is OUT. 7. Push the accelerator pedal to just past the engine stopped detent. 8. Push in and TURN the start switch to START. Release the switch when the engine starts.
After every 30 seconds of cranking, allow 2 minutes for the starting motor to cool.
9. If the engine oil pressure gauge does not register within 10 seconds, stop the engine by pulling up on the accelerator pedal. Have corrections made.10. Keep the engine at low idle until the systems are warm.11. Watch all gauges and indicators. They must have correct readings before moving the machine.Below 0°C (32°F)
1. Follow the steps under "Above 0°C (32°F)."
If the engine does not start after two attempts, use starting fluid. This will prevent excessive battery drain and starting