Buy 29405-00421 PUMP ASSY, SUPPLY Denso Cross


Rating:
46
Buy PUMP ASSY, SUPPLY 29405-00421 genuine, new aftermarket engine parts with delivery

Information pump assy, supply Denso

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$866.77

25 Nov 2024
0.1102[0.05] Pounds
CN: jiaxuan1227
Diesel Fuel Injection Pump 294050-0420 294050-0421 294050-0422 294050-0423 294050-0424 8-97605946-8 Compatible With ISUZU 6HK1
HXYAIEOGD Ensure the continuous and stable operation of the engine. || The installation procedure is simple. || Ensure OE number before placing order. || The warranty period is 12 months. || 1 piece jet pump
$866.77

25 Nov 2024
0.1102[0.05] Pounds
CN: jiaxuan1227
Diesel Fuel Injection Pump 294050-0420 294050-0421 294050-0422 294050-0423 294050-0424 8-97605946-8 Compatible With ISUZU 6HK1
HXYAIEOGD Ensure the continuous and stable operation of the engine. || The installation procedure is simple. || Ensure OE number before placing order. || The warranty period is 12 months. || 1 piece jet pump
$866.39

25 Nov 2024
0.1102[0.05] pounds
CN: jiaxuan1227
HP4 Common Rail Diesel Fuel Injection Pump 8-97605946-7 294050-0421 294050-0422 294050-0423 Compatible With ISUZU 6HK1
HXYAIEOGD Ensure the continuous and stable operation of the engine. || The installation procedure is simple. || Ensure OE number before placing order. || The warranty period is 12 months. || 1 piece jet pump

Include in ##:

Number on scheme 000
PUMP ASSY, SUPPLY
29405-00420 as PUMP ASSY, SUPPLY

Cross reference number



Part num
Firm num
Firm
Name
29405-00421 
8-97605946 
PUMP ASSY, SUPPLY




Information:

* Inspect the radiator for leaks and trash build-up. * Inspect the radiator hoses for cracks and loose clamps.* Inspect the fan and accessory drive belts for cracks, breaks or other damage. Belts for multiple groove pulleys are sold in matched sets. Belts for multiple groove pulleys must be replaced as matched sets. If only one belt of a two or three belt set is replaced, it will carry more of a load than the belts not replaced since the older belts are stretched. The additional load on the new belt could cause it to break. * Inspect the water pump for leaks. The water pump seal is lubricated by coolant in the cooling system. It is normal for a small amount of leakage to occur as the engine cools down and parts contract. * Inspect the engine for oil leaks, such as front and rear crankshaft seals, crankcase, oil filter and valve covers.* Inspect the fuel system for leaks, loose fuel line clamps and fittings and loose or worn hoses. If leaking is observed, find the source and correct the leak. If leaking is suspected, check the fluid levels more frequently than the recommended service intervals prescribed in this publication until a leak is found or fixed, or until the suspicion for a leak has been proven to be unwarranted. * Inspect wiring for loose connections and worn or frayed wires.* Inspect air intake system hoses and elbows for cracks and loose clamps.* Inspect engine-to-frame ground strap for good connection and condition.Pre-Start Checks
* Measure the engine crankcase oil level. The correct oil level is shown by the marks between the words "ADD" and "FULL RANGE" on the dipstick (oil level gauge) on the "Engine Stopped" side.The location of the ADD and FULL RANGE marks on the engine dipstick are determined by the tilt angle of the engine after it is installed in the truck.If the ADD and FULL RANGE marks have not been stamped on the dipstick, see "Calibration" in the "Dipsticks" section of this manual or contact your authorized Caterpillar dealer. * Check the coolant level with the engine stopped and cold. Remove the filler cap slowly to relieve pressure.* Maintain the coolant level to within 1/2 inch (13 mm) of the bottom of the fill pipe. Install the filler cap.* If equipped with a sight glass, maintain the coolant to the proper level.
To prevent engine damage, never add coolant to an overheated engine. Allow the engine to cool first.
Typical Example* Observe the air cleaner service indicator (if equipped). Service the air cleaner when the yellow diaphragm enters the red zone or the red piston locks in the visible position. If your truck air cleaner is not equipped with an indicator, your authorized Caterpillar dealer can provide one for you.* Check fuel level. Do not fill fuel tank to top. Fuel expands as it gets warm and may overflow.

Have questions with 29405-00421?





Group cross 29405-00421

Back to top