Rating:
Information pump assy, supply Denso
Product
Fuel Injection Pump
Vehicle engine
N SERIES 4HK1
Engine
4HK1
Serial start-end
1003-
Info
Injector Nozzle
Components :
Scheme #.#:
№
Qty
Part num
Name
Remarks
Manufacture num
000
[01]
29400-01130
PUMP ASSY, SUPPLY
HP3 #
8-98081772-1
ISUZU
Include in ##:
29400-01130
as PUMP ASSY, SUPPLY
Cross reference number
Part num
Firm num
Firm
Name
29400-01130
8-98081772
PUMP ASSY, SUPPLY
2940001130
8-98081772-0
ISUZU
PUMP ASSY SUPPLY
2940001130
8-98081772-1
ISUZU
PUMP ASSY, SUPPLY
2940001130
8-98081772-3
ISUZU
PUMP ASSY, SUPPLY
2940001130
8-98081772-4
ISUZU
PUMP ASSY, SUPPLY
Test Calibration Data:
02EN113000
8-98081772-1
02EN113000
8-98081772-1
02EN113000
8-98081772-1
Information:
Engine Crankshaft Will Not Turn
Recommended Procedure
1. Low or No Battery Voltage ... Check battery voltage. If battery voltage is less than 8 volts for a 12 volt system, or 16 volts for a 24 volt system, put a charge to the battery. If battery will not hold a charge, load test the battery as shown in the Electrical System of the Testing and Adjusting section of this Service Manual.2. Bad Switch, Bad Wiring or Connection in Switch Circuit ... With ignition switch in START position, check voltage at switch connection on starter solenoid. If there is no voltage, or if the voltage is low at this connection, check wiring, connections, ignition switch, and magnetic switch (if used).3. Bad Cable or Connection; Battery to Starter ... With ignition switch in the START position, check voltage at connection of battery cable to starter. If there is no voltage, or if the voltage is low at this
Recommended Procedure
1. Low or No Battery Voltage ... Check battery voltage. If battery voltage is less than 8 volts for a 12 volt system, or 16 volts for a 24 volt system, put a charge to the battery. If battery will not hold a charge, load test the battery as shown in the Electrical System of the Testing and Adjusting section of this Service Manual.2. Bad Switch, Bad Wiring or Connection in Switch Circuit ... With ignition switch in START position, check voltage at switch connection on starter solenoid. If there is no voltage, or if the voltage is low at this connection, check wiring, connections, ignition switch, and magnetic switch (if used).3. Bad Cable or Connection; Battery to Starter ... With ignition switch in the START position, check voltage at connection of battery cable to starter. If there is no voltage, or if the voltage is low at this