Rating:
Information pump assy, injecti Denso
Product
Fuel Injection Pump
Vehicle engine
L200/TRITON 4D56
Engine
4D56
Serial start-end
9811--0008
Info
Injector Nozzle
093500-6210
Manufacture:
MD361650 MITSUBISHI
Dim 1
3.2-3.4
Dim 2
5.2-5.4
Dim 3
1.35-1.55
Dim 4
Dim 5
Dim 6
Information
Injector nozzle:
0935006210
KIT List:
Part name
Kit1
Kit2
Components :
Scheme #.#:
№
Qty
Part num
Name
Remarks
Manufacture num
000
[01]
19600-03030
PUMP ASSY, INJECTI
MD361650
MITSUBISHI
Include in ##:
19600-03030
as PUMP ASSY, INJECTI
Cross reference number
Part num
Firm num
Firm
Name
19600-03030
MD361650
PUMP ASSY, INJECTI
1960003030
MD361650
MITSUBISHI
PUMP ASSY, INJECTI
Information:
1. Put compression on valve spring (2) with Tool (A). Remove locks (1).2. Remove Tool (A), rotocoil, spring, valve stem oil shield and valve. Put identification marks on valves with respect to their location in the cylinder head. 3. Check the spring force with Tool (B). The spring force is 257 25 N (57.8 5.6 lb). The length of spring under test force is 44.86 mm (1.766 in). The free length after test is 52.07 mm (2.050 in).4. Do Steps 1 through 3 again for the remainder of the valves.Install Valves
1. Put clean engine oil on the valve stems. Install valve (3), oil shield (4), spring (2) and rotocoil (1) in the cylinder head. 2. Put Tool (A) in position on the valve spring. Install the locks with Tool (B).
Locks can be thrown from valve when the compressor is released if they are not in their correct position on valve stem. Personal injury can be the result if not carefully removed.
3. Remove Tool (A), and hit the top of valve with a plastic hammer to be sure the locks are in their correct position on valve.4. Do Steps 1 through 3 again for the remainder of the valves.End By:a. install cylinder head assembly and spacer plateb. install fuel injection nozzles
1. Put clean engine oil on the valve stems. Install valve (3), oil shield (4), spring (2) and rotocoil (1) in the cylinder head. 2. Put Tool (A) in position on the valve spring. Install the locks with Tool (B).
Locks can be thrown from valve when the compressor is released if they are not in their correct position on valve stem. Personal injury can be the result if not carefully removed.
3. Remove Tool (A), and hit the top of valve with a plastic hammer to be sure the locks are in their correct position on valve.4. Do Steps 1 through 3 again for the remainder of the valves.End By:a. install cylinder head assembly and spacer plateb. install fuel injection nozzles