Rating:
Information pump assy, injecti Denso
Product
Fuel Injection Pump
Vehicle engine
CAMRY 3C-T
Engine
3C-T
Serial start-end
9501--9806
Info
Injector Nozzle
093500-5820
Manufacture:
22100-6D740 TOYOTA
Dim 1
3.2-3.4
Dim 2
5.2-5.4
Dim 3
0.7-0.9
Dim 4
Dim 5
Dim 6
Information
Injector nozzle:
0935005820
KIT List:
Part name
Kit1
Kit2
Cross reference number
Part num
Firm num
Firm
Name
1960000020
22100-6D740
TOYOTA
PUMP ASSY, INJECTI
Test Calibration Data:
1960000020
22100-6D740
1960000021
22100-6D740
1960000022
22100-6D740
Information:
(8) Bore in bearing for balancer shaft (installed) ... 53.050 0.061 mm (2.0886 .0024 in) Bore in block for bearings ... 57.851 .025 mm (2.2776 .0010 in)Depth to install bearings at both ends of block ... 0.8 0.5 mm (.03 .02 in)(9) Depth from front face of block to install center bearings ... 290.6 0.5 mm (11.44 .02 in)
There are holes in the bores for the main bearings, between the cylinders for piston cooler orifices. These holes must have either orifices (11) or plugs (10) installed.
(10) Plug.(11) Piston cooling orifice. (12) Distance two dowels extend from the surface of the cylinder block ... 19.8 0.5 mm (.78 .02 in)(13) Distance hollow dowel extends from the surface of the cylinder block ... 16.0 0.5 mm (.63 .02 in)(14) Depth to install two dowels below the surface of the cylinder block ... 1.0 0.5 mm (.04 .02 in)(15) Distance dowel extends from the front face of the cylinder block ... 15.7 0.5 mm (.62 .02 in)(16) Distance two dowels extend from the rear face of the cylinder block ... 12.7 0.5 mm (.50 .02 in)(17) Distance dowel extends from the front face of the cylinder block ... 22.4 0.5 mm (.88 .02 in)
There are holes in the bores for the main bearings, between the cylinders for piston cooler orifices. These holes must have either orifices (11) or plugs (10) installed.
(10) Plug.(11) Piston cooling orifice. (12) Distance two dowels extend from the surface of the cylinder block ... 19.8 0.5 mm (.78 .02 in)(13) Distance hollow dowel extends from the surface of the cylinder block ... 16.0 0.5 mm (.63 .02 in)(14) Depth to install two dowels below the surface of the cylinder block ... 1.0 0.5 mm (.04 .02 in)(15) Distance dowel extends from the front face of the cylinder block ... 15.7 0.5 mm (.62 .02 in)(16) Distance two dowels extend from the rear face of the cylinder block ... 12.7 0.5 mm (.50 .02 in)(17) Distance dowel extends from the front face of the cylinder block ... 22.4 0.5 mm (.88 .02 in)