19100-00030 PUMP ASSY, INJECTI Calibration Data


Rating:
54
Buy PUMP ASSY, INJECTI 19100-00030 genuine, new aftermarket engine parts with delivery

Information pump assy, injecti Denso

Product
Fuel Injection Pump
Vehicle engine
agricultural machine 6619A
Engine
6619A
Serial start-end
8503--9003
Info
Injector Nozzle
093500-2420
Injector nozzle: 0935002420

KIT List:

Part name
Kit1
Kit2
Body assy, injecti
Governor assy, mec
Pump assy, fuel fe

Components :

00.001
PUMP ASSY, INJECTI
P6,RSV
01.002
BODY ASSY, INJECTI
P6
01.003
GOVERNOR ASSY, MEC
RSV
02.004
COMPENSATOR SUB-AS
01.005
PUMP ASSY, FUEL FE
KE

Scheme #.#:

Qty
Part num
Name
Remarks
Manufacture num
000
[01]
19100-00030
PUMP ASSY, INJECTI
P6,RSV
001
[01]
BODY ASSY, INJECTI
P6
002
[01]
GOVERNOR ASSY, MEC
RSV
003
[01]
PUMP ASSY, FUEL FE
KE
004
[01]
BLOCK, COUPLING
005
[01]
WASHER, SPRING
T2.8
006
[01]
NUT, HEXAGON
M18
011
[01]
COVER, CONTROL RAC
012
[01]
WASHER, COPPER PLA
T2
013
[08]
BOLT, W/WASHER
M6,L20
014
[01]
KEY, WOODRUFF
W5,H7.5
017
[01]
O-RING
ID90
019
[01]
BOLT, HEXAGON
M6,L22

Include in ##:

19100-00030 as PUMP ASSY, INJECTI

Cross reference number



Part num
Firm num
Firm
Name
19100-00030 
 
PUMP ASSY, INJECTI

Test Calibration Data:

1910000030 RE19805




Information:

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
It has been difficult to detect a faulty injector harness or a faulty injector on the engines that are listed above.Solution
Until further notice, this procedure should be used when you are troubleshooting failures of the injector on the engines that are listed above. If a truck is in the shop for symptoms of failure of the injector and a cylinder cutout test shows a cylinder with a lower number than the rest, follow the procedure that is listed below.
Determine the cylinder that is receiving insufficient fuel.
Switch the low number cylinder injector with a normal number cylinder injector.
If the low number cylinder injector follows to the new position, replace the injector. If the low number cylinder injector does not follow to the new position, replace the harness.Refer to the example in Table 1. Switch the injectors for cylinders 3 and 4 in order to reduce the time for removal of the "VVA" housings.
Table 1
Cylinder     Reading    
1     23.55    
2     24.02    
3     23.30    
4     20.02    
5     22.5    
6     23.2    

Have questions with 19100-00030?





Group cross 19100-00030

Back to top