09600-04690 PUMP ASSY, INJECTI Calibration Data

Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Caterpillar Channel 1 Videos
For supplemental information on this procedure, refer to the following video. The previous training has been replaced with the video below.Note: A CWS login is required to access Caterpillar Channel 1. Scan the QR code below with a QR enabled device or copy the link that follows.
Illustration 1 g06306276https://channel1.mediaspace.kaltura.com/media/Introduction+to+Visualization+Service+Procedures+%28VSP%29/1_92vjr92v
Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Personal injury can result from improper handling of chemicals.Make sure you use all the necessary protective equipment required to do the job.Make sure that you read and understand all directions and hazards described on the labels and material safety data sheet of any chemical that is used.Observe all safety precautions recommended by the chemical manufacturer for handling, storage, and disposal of chemicals.
Before servicing/performing maintenance on the machine, electrical power must be physically disconnected; battery plugs must be disconnected from the batteries, or the trailing cable must be unplugged, and warning tags and padlocks shall be applied by a certified electrician. Certified electricians shall perform or direct any electrical work, including any energized testing, repair work in controllers, motors, or other approved compartments, and shall insure that all compartments are properly closed and inspected prior to re-energization. All applicable lock out and tag out procedures must be followed.
Serial Number Reference
The tables that follow below contain the suspected cylinder for each engine serial and the corresponding fuel injector part number and injector serial number. Replace these fuel injectors with known good fuel injectors to help prevent damage that may occur from internal defects of the previous fuel injectors.
Table 1
S/N:MR900203 Suspect Fuel Injectors
Cyl Injector Part Number Injector Serial Number
1 373-5507 8C00599017C0
2 373-5507 8C00599023E3
3 373-5507 8C00599020EA
4 373-5507 8C00599024F6
5 373-5507 8C00599026F8
6 373-5507 8C00599021ED
7 373-5507 8C00599032F1
8 373-5507 8C00599031F8
9 373-5507 8C00599029D5
10 373-5507 8C00599027FF
11 373-5507 8C00599018ED
12 373-5507 8C00599030FF
13 373-5507 8C00599022E4
14 373-5507 8C00599028D2
15 373-5507 8C00599019EA
16 373-5507 8C00599025F1
Table 2
S/N:SBK02534 Suspect Fuel Injectors
Cyl Injector Part Number Injector Serial Number
1 392-0216 2067902
2 392-0216 2067881
3 392-0216 2067859
4 392-0216 2067887
5 392-0216 2067897
6 392-0216 2067862