Rating:
Information pump assy, injecti Denso
Product
Fuel Injection Pump
Vehicle engine
COROLLA 1C-L
Engine
1C-L
Serial start-end
8505--8704
Info
Injector Nozzle
093500-3240
Manufacture:
22100-64740 TOYOTA
Dim 1
3.2-3.4
Dim 2
5.8-6.0
Dim 3
-
Dim 4
Dim 5
Dim 6
Information
Injector nozzle:
0935003240
KIT List:
Part name
Kit1
Kit2
Components :
Scheme #.#:
№
Qty
Part num
Name
Remarks
Manufacture num
000
[01]
09600-02290
PUMP ASSY, INJECTI
22100-64740
TOYOTA
Include in ##:
09600-02290
as PUMP ASSY, INJECTI
Cross reference number
Part num
Firm num
Firm
Name
09600-02290
22100-6474
PUMP ASSY, INJECTI
0960002290
22100-64740
TOYOTA
PUMP ASSY, INJECTI
Information:
Interfacing With a Shipyard
Provide table 3, table 4, table 7, table 8, and table 9.Provide the following list of information about the MMS configuration:
The MMS protocol for output is Modbus.
Ports for hardware are available. The ports have 9 pins. The RS-485 has one connection with 2 wires and two connections with 4 wires. The RS-232C has one handshaking connection and two connections without handshaking.
Provide the list of baud rates.
The network addresses can be a number between 1 and 247.
The system uses a serial cable that has 9 pins. The cable has shielding.Control System Inputs to PLC Redundant Relay Logic
Table 1
ISA TAG # PLC CARD # SENSOR DESCRIPTION PLC REG ASSIGN SIGNAL TYPE ALARM SHUT DOWN SETPOINT TRIP COMMENTS
PRESSURE CONTACTORS
PSLL-001 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
105 kPa (15.2 psi) Low Speed
PSLL-002 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
260 kPa (37.7 psi) High Speed
PSHH-003 PLC01 Engine High Crankcase Pressure: 117-1864 N7:07/11 DIGITAL X >
1 kPa (4.0 inch of H2O) Enable When Fuel is On
PSL-004 PLC02 Low Air Starting Pressure: 117-1864 N7:07/12 DIGITAL X <
750 kPa (108.8 psi) Removed if Transducer is Ordered
PSL-005 PLC02 Sea Water Low Pressure: N7:01/08 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
PSL-006 PLC02 Low Jacket Water Pressure: 144-0102 N7:01/10 DIGITAL X <
20 kPa (2.9 psi) (Low RPM)
<
35 kPa (5.1 psi) (High RPM) Removed if Transducer is Ordered
PSL-007 PLC02 Low AC/OC Circuit Water Pressure: 144-0102 N7:01/12 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
SWITCHES/MISC CONTACTS
YSL-001 PLC01 Low Battery Voltage: 7C-3508 N7:07/09 DIGITAL X < 22 VDC Monitors Dc to MMS
LSL-001 PLC02 Jacket Water Detection: 125-4340 N7:01/15 DIGITAL X Contact Close Energizes RJWDA Relay
HS-001 PLC01 Emergency Stop (Local) N7:07/06 DIGITAL X Contact Close Shuts Off Fuel And Air to Engine
SS-001 PLC01 Engine Speed Switch Crank Terminate: 100-5675 I:1.0/9 DIGITAL > 170 RPM & < 0 + 2 Sec
SS-006 Engine Speed Switch Alarm Time Delay: 100-5675 DIGITAL 9 Sec After SS-001 Enables Alarms and Shutdowns
SS-007 Engine Speed Switch Oil Pressure Step: 100-5675 DIGITAL 75%
Provide table 3, table 4, table 7, table 8, and table 9.Provide the following list of information about the MMS configuration:
The MMS protocol for output is Modbus.
Ports for hardware are available. The ports have 9 pins. The RS-485 has one connection with 2 wires and two connections with 4 wires. The RS-232C has one handshaking connection and two connections without handshaking.
Provide the list of baud rates.
The network addresses can be a number between 1 and 247.
The system uses a serial cable that has 9 pins. The cable has shielding.Control System Inputs to PLC Redundant Relay Logic
Table 1
ISA TAG # PLC CARD # SENSOR DESCRIPTION PLC REG ASSIGN SIGNAL TYPE ALARM SHUT DOWN SETPOINT TRIP COMMENTS
PRESSURE CONTACTORS
PSLL-001 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
105 kPa (15.2 psi) Low Speed
PSLL-002 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
260 kPa (37.7 psi) High Speed
PSHH-003 PLC01 Engine High Crankcase Pressure: 117-1864 N7:07/11 DIGITAL X >
1 kPa (4.0 inch of H2O) Enable When Fuel is On
PSL-004 PLC02 Low Air Starting Pressure: 117-1864 N7:07/12 DIGITAL X <
750 kPa (108.8 psi) Removed if Transducer is Ordered
PSL-005 PLC02 Sea Water Low Pressure: N7:01/08 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
PSL-006 PLC02 Low Jacket Water Pressure: 144-0102 N7:01/10 DIGITAL X <
20 kPa (2.9 psi) (Low RPM)
<
35 kPa (5.1 psi) (High RPM) Removed if Transducer is Ordered
PSL-007 PLC02 Low AC/OC Circuit Water Pressure: 144-0102 N7:01/12 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
SWITCHES/MISC CONTACTS
YSL-001 PLC01 Low Battery Voltage: 7C-3508 N7:07/09 DIGITAL X < 22 VDC Monitors Dc to MMS
LSL-001 PLC02 Jacket Water Detection: 125-4340 N7:01/15 DIGITAL X Contact Close Energizes RJWDA Relay
HS-001 PLC01 Emergency Stop (Local) N7:07/06 DIGITAL X Contact Close Shuts Off Fuel And Air to Engine
SS-001 PLC01 Engine Speed Switch Crank Terminate: 100-5675 I:1.0/9 DIGITAL > 170 RPM & < 0 + 2 Sec
SS-006 Engine Speed Switch Alarm Time Delay: 100-5675 DIGITAL 9 Sec After SS-001 Enables Alarms and Shutdowns
SS-007 Engine Speed Switch Oil Pressure Step: 100-5675 DIGITAL 75%