Rating:
Information pump assy, injecti Denso
Product
Fuel Injection Pump
Vehicle engine
INDUSTRIAL L2A-61A
Engine
L2A-61A
Serial start-end
8603--8906
Info
Injector Nozzle
093500-3350
Injector nozzle:
0935003350
Components :
Scheme #.#:
№
Qty
Part num
Name
Remarks
Manufacture num
000
[01]
09450-03870
PUMP ASSY, INJECTI
PFR2NC
Include in ##:
09450-03870
as PUMP ASSY, INJECTI
Cross reference number
Part num
Firm num
Firm
Name
09450-03870
PUMP ASSY, INJECTI
Information:
Below Normal Heating
Long Idle Periods ... When the engine is running with no load, only a small quantity of fuel is being burned and engine heat is removed too fast.Very Light Load ... Very light loads, and a very slow speed or downhill travel can cause below normal heating because of the low heat input of the engine. The installation of shutters helps to correct this condition.Defective Thermostat(s) ... Thermostat(s) that are "stuck" open (will not move to the closed position) will cause below normal heating. A thermostat that is stuck between the open and closed positions or only opens part of the way can cause below normal heating when the truck has a light load.*Authorized dealers are equipped with the necessary tools and personnel familiar with disassembly and assembly procedures to perform these services.
Long Idle Periods ... When the engine is running with no load, only a small quantity of fuel is being burned and engine heat is removed too fast.Very Light Load ... Very light loads, and a very slow speed or downhill travel can cause below normal heating because of the low heat input of the engine. The installation of shutters helps to correct this condition.Defective Thermostat(s) ... Thermostat(s) that are "stuck" open (will not move to the closed position) will cause below normal heating. A thermostat that is stuck between the open and closed positions or only opens part of the way can cause below normal heating when the truck has a light load.*Authorized dealers are equipped with the necessary tools and personnel familiar with disassembly and assembly procedures to perform these services.