09210-02853 PUMP ASSY, FUEL FE Denso Cross


Rating:
59
Buy PUMP ASSY, FUEL FE 09210-02853 genuine, new aftermarket engine parts with delivery

Information pump assy, fuel fe Denso

Scheme #.#:

Qty
Part num
Name
Remarks
Manufacture num
000
[01]
09210-02853
PUMP ASSY, FUEL FE
KD22
002
[01]
HOUSING SUB-ASSY,
-9511
002
[01]
HOUSING SUB-ASSY,
9511-
002-001
[01]
ROD, FEED PUMP PUS
002-002
[01]
SEAL, OIL
003
[04]
VALVE, FEED PUMP C
004
[04]
SPRING, FEED PUMP
005
[04]
GASKET, CHECK VALV
006
[03]
PLUG, FEED PUMP CH
007
[01]
PUMP SUB-ASSY, PRI
ALUMINUM -9705
007
[01]
PUMP SUB-ASSY, PRI
9705--9710
007
[01]
PUMP SUB-ASSY, PRI
9711-
009
[01]
PISTON, FEED PUMP
BLUE
010
[01]
SPRING, FEED PUMP
DISCONTINUED -9701
011
[01]
TAPPET, FEED PUMP
012
[01]
ROLLER, FEED PUMP
013
[01]
PIN, FEED PUMP TAP
014
[02]
BLOCK, FEED PUMP T
015
[01]
SPRING, FEED PUMP
016
[01]
PLUG, FEED PUMP PI
021
[01]
WASHER, COPPER PLA
T1
023
[01]
RING, SNAP
ID28

Include in ##:

09210-02853 as PUMP ASSY, FUEL FE

Cross reference number



Part num
Firm num
Firm
Name
09210-02853 
 
PUMP ASSY, FUEL FE




Information:


DO NOT adjust the linkage so the treadle can be used to shut off the engine. If the operator is in a standing position and places a foot on the treadle, the engine could be unexpectedly shut off, creating a situation where the machine can be difficult to control.
814B, 815B, 816B, 966D
1. Set governor shaft to the off position (approximately 35° right of twelve o'clock) and attach lever (1).2. Adjust cable assembly (2) to within 3 mm (.12 in) of the end of travel and tighten bulkhead (3) nuts to ... 100 15 N m (75 11 lb ft)3. With pedal (4) in off position (approximately 66 3° up from floor plate) attach cable assembly (2) to lever (6).4. Tighten bulkhead nuts at pedal end of cable assembly to ... 100 15 N m (75 11 lb ft)5. Set governor lever (1) to high idle and adjust bolt (5) until it contacts pedal.528
1. Move governor shaft (3) to Shutoff position and install lever (2) on shaft (3) at angle shown.2. Position pedal assembly (1) to dimension A above stop (4) by adjusting rod assembly (5). Dimension A ... 49 1 mm (1.93 .04 in)3. Tighten nut (6) to a torque of ... 45 7 N m (33 5 lb ft)

Have questions with 09210-02853?





Group cross 09210-02853

Back to top