09200-00170 PUMP ASSY, INJECTI Calibration Data


Rating:
22
Buy PUMP ASSY, INJECTI 09200-00170 genuine, new aftermarket engine parts with delivery

Information pump assy, injecti Denso

Product
Fuel Injection Pump
Vehicle engine
INDUSTRIAL 6D125
Engine
6D125
Serial start-end
9206--9307
Info
Injector Nozzle
093500-2710
Injector nozzle: 0935002710

KIT List:

Part name
Kit1
Kit2
Pump assy, fuel fe
Body assy, injecti
Governor assy, mec

Components :

00.001
PUMP ASSY, INJECTI
NB6,RSV -0011
00.001
PUMP ASSY, INJECTI
NB6,RSV 0011-
01.002
PUMP ASSY, FUEL FE
KE
01.003
COUPLING ASSY
SD
01.004
BODY ASSY, INJECTI
NB6
02.005
COVER, BEARING
DUMMY
01.006
GOVERNOR ASSY, MEC
RSV

Scheme #.#:

Qty
Part num
Name
Remarks
Manufacture num
000
[01]
09200-00170
PUMP ASSY, INJECTI
NB6,RSV -0011
000
[01]
PUMP ASSY, INJECTI
NB6,RSV 0011-
003
[01]
BODY ASSY, INJECTI
NB6
004
[01]
GOVERNOR ASSY, MEC
RSV
005
[02]
BOLT, W/WASHER
006
[01]
COVER, CONTROL RAC
007
[01]
NUT, TIMER ROUND
008
[01]
WASHER, COUNTERSUN
T1.5
009
[01]
KEY, WOODRUFF
W5,H7.5
010
[01]
PUMP ASSY, FUEL FE
KE
011
[01]
COVER, PRIMING PUM
012
[01]
WASHER, COPPER PLA
T1.5
014
[01]
COUPLING ASSY
SD
015
[02]
WASHER, FUEL PIPE
016
[01]
VALVE ASSY, OVERFL
1.5-1.7K
017
[01]
BOLT, W/WASHER
018
[04]
BOLT, W/WASHER
M8,L16
021
[01]
BOLT, W/WASHER
M8,L22

Include in ##:

09200-00170 as PUMP ASSY, INJECTI

Cross reference number



Part num
Firm num
Firm
Name
09200-00170 
 
PUMP ASSY, INJECTI

Test Calibration Data:

0920000170 6150-71-2612




Information:

Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Caterpillar Channel 1 Videos
For supplemental information on this procedure, refer to the following video. The previous training has been replaced with the video below.Note: A CWS login is required to access Caterpillar Channel 1. Scan the QR code below with a QR enabled device or copy the link that follows.
Illustration 1 g06306276https://channel1.mediaspace.kaltura.com/media/Introduction+to+Visualization+Service+Procedures+%28VSP%29/1_92vjr92v
Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Personal injury can result from improper handling of chemicals.Make sure you use all the necessary protective equipment required to do the job.Make sure that you read and understand all directions and hazards described on the labels and material safety data sheet of any chemical that is used.Observe all safety precautions recommended by the chemical manufacturer for handling, storage, and disposal of chemicals.
Before servicing/performing maintenance on the machine, electrical power must be physically disconnected; battery plugs must be disconnected from the batteries, or the trailing cable must be unplugged, and warning tags and padlocks shall be applied by a certified electrician. Certified electricians shall perform or direct any electrical work, including any energized testing, repair work in controllers, motors, or other approved compartments, and shall insure that all compartments are properly closed and inspected prior to re-energization. All applicable lock out and tag out procedures must be followed.
Serial Number Reference
The tables that follow below contain the suspected cylinder for each engine serial and the corresponding fuel injector part number and injector serial number. Replace these fuel injectors with known good fuel injectors to help prevent damage that may occur from internal defects of the previous fuel injectors.
Table 1
S/N:MR900203 Suspect Fuel Injectors
Cyl Injector Part Number Injector Serial Number
1 373-5507 8C00599017C0
2 373-5507 8C00599023E3
3 373-5507 8C00599020EA
4 373-5507 8C00599024F6
5 373-5507 8C00599026F8
6 373-5507 8C00599021ED
7 373-5507 8C00599032F1
8 373-5507 8C00599031F8
9 373-5507 8C00599029D5
10 373-5507 8C00599027FF
11 373-5507 8C00599018ED
12 373-5507 8C00599030FF
13 373-5507 8C00599022E4
14 373-5507 8C00599028D2
15 373-5507 8C00599019EA
16 373-5507 8C00599025F1
Table 2
S/N:SBK02534 Suspect Fuel Injectors
Cyl Injector Part Number Injector Serial Number
1 392-0216 2067902
2 392-0216 2067881
3 392-0216 2067859
4 392-0216 2067887
5 392-0216 2067897
6 392-0216 2067862

Have questions with 09200-00170?





Group cross 09200-00170

Back to top