09340-07550 NOZZLE ASSY Denso Cross

Inspection points1. Main bearing installation (1) Install the upper halves of the main bearings in the cylinder block and the lower halves in the main bearing caps so lower halves in the main bearing caps so their tabs fit into the notches in the cylinder block and the main bearing caps.(2) Install the flanged bearing in the No. 3 journal.(3) Lightly lubricate the inside surfaces of the bearings with engine oil.
Installing main bearings2. Crankshaft installation (1) Clean the crankshaft with cleaning solvent and blow dry with compressed air. (2) Fasten a hoist to the crankshaft and hold it in horizontal position. Carefully put the crankshaft in position in the cylinder block.(3) Lightly lubricate the crankshaft journals with engine oil.
Installing crankshaft3. Main bearing cap installation (1) Coat the mating surfaces of the rear bearing cap and cylinder block with Three Bond 1212. (2) Install the main bearing caps in position. Make sure the number (arrow head) on the main bearing cap is toward the front of the engine.(3) Tighten the main bearing cap bolts finger tight only.
Main bearing caps installed
Install the front and rear bearing caps in position so their end faces are even with the end faces of the cylinder block.
Installing front and rear bearing caps(4) Tighten the bolts holding the main bearing caps in steps to the specified torque.
Tightening bolts holding main bearing caps(5) Make sure the crankshaft rotates freely without binding or catching.(6) Measure the end play for the crankshaft. Make reference to "End play measurement for crankshaft" (page 42). If the end play is incorrect, loosen the bolts holding the main bearing caps once and tighten them again.
Checking crankshaft for rotation4. Side seal installation (1) Coat the side seals with Three Bond 1212.(2) Insert the side seals between the cylinder block and the front and rear caps and push in them by hand as far as possible, with their rounded side toward the outside of the cylinder block.
Side seals(3) Using a flat plate, push the seals into position, taking care not to bend them.
Installing side seals5. Piston assembling to connecting rod(1) Set Piston Setting Tool (31A91-00100) (special tool) in a hydraulic press.(2) Put