09340-01360 NOZZLE ASSY Denso Cross

Walk-Around Inspection
For maximum service life of your engine, make a thorough inspection of the engine compartment before starting the engine. Look for items such as oil or coolant leaks, loose bolts, and trash buil-up. Remove trash buil-up and have repairs made as needed. It only takes a few minutes to make minor corrections. This can prevent major repairs at a later date.* Perform required Daily and other periodic maintenance before starting the engine. Refer to the Maintenance Schedule Daily maintenance recommendations in this manual for details.* Clean all fittings, caps, and plugs before servicing.* Inspect the cooling system hoses for cracks and loose clamps.* Check the air cleaner service indicator (if equipped). Service the air cleaner filter element when the yellow diaphragm enters the red zone, or the red piston locks in the visible position.* Make sure the air inlet piping is in place. Inspect the air inlet piping for good connections.* Inspect the fan belts and accessory drive belts for cracks, breaks, and other damage.* Inspect the wiring for loose connections and for worn or frayed wires.
Any time oil (or other fluid) is spilled on or near the engine it should be cleaned up. Accumulated grease and oil on an engine or platform is a fire hazard. Remove this debris with steam cleaning or high pressure water each time any oil (or other fluid) is spilled on or near an engine and working area.
* Check the fuel supply. Drain water from the water separator (if equipped). Open the fuel supply valve.
All valves in fuel return line must be open before and during engine operation to prevent high fuel pressure. High fuel pressure may cause filter housing failure or other damage.
If the engine has not been run for several weeks, fuel may have drained and allowed air into the filter housing. Also, when fuel filters have been changed, some air space will be left in the housing. In these instances, prime the fuel system. Refer to Priming the Fuel System in this publication for more information.* Open the sea water valve on the engine jacket heat exchanger system (if equipped).* Place the transmission in NEUTRAL.
Diesel engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well-ventilated area and, if in an enclosed area, vent the exhaust to the outside.
* Do not start the engine or move any of the controls if there is a DO NOT OPERATE or similar warning tag attached to the start switch or controls.* The operator must be satisfied that no one will be endangered before starting the engine.* Disconnect any battery chargers that are not protected against the high current drain created when the electric starter engages. Check electrical cables and the battery for poor connections and corrosion.* Reset any shutoff or alarm components. * Check for damaged or missing guards. Repair or replace any damaged or missing guards.* Check the oil level. Maintain the oil level between the ADD and