Rating:
Information element kit, suppl Denso
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
IMIFAFTAbT 294090-0870 2940900870 Common Rail High Pressure Pump Plunger Fits for Denso HP4 series Fuel injection pump
IMIFAFTAbT Product Name: 294090-0870 2940900870 Common Rail High Pressure Pump Plunger || Part number: 294090-0870 2940900870 || Fits for Denso HP4 series Fuel injection pump || 1 PCS Common Rail High Pressure Pump Plunger || Note: Please confirm that the product shown in the part number is what you need. If you cannot confirm you can leave us a message and provide your engine serial number and nameplate
IMIFAFTAbT Product Name: 294090-0870 2940900870 Common Rail High Pressure Pump Plunger || Part number: 294090-0870 2940900870 || Fits for Denso HP4 series Fuel injection pump || 1 PCS Common Rail High Pressure Pump Plunger || Note: Please confirm that the product shown in the part number is what you need. If you cannot confirm you can leave us a message and provide your engine serial number and nameplate
Include in ##:
Number on scheme 016
29405-00027
as ELEMENT KIT, SUPPL
Cross reference number
Part num
Firm num
Firm
Name
29409-00870
ELEMENT KIT, SUPPL
Information:
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Disconnect the battery (turn disconnect switch OFF) when changing fuel filters.
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Close the fuel supply valve at the tank before servicing filters. Open the valve after filter servicing is completed.Cleaning Primary Filter
Use all cleaning solutions with care.
1. Loosen the nut (1) on the filter cover and lower the filter case (3).2. Remove the element (2). Wash the cover and element in clean nonflammable solvent.3. Reinstall the element.4. Install the element and case onto the cover into the case.5. Tighten the bolt.Changing Secondary Filter
1. Unscrew filter element. Throw away the used element. 2. Make certain all of the used element seal is cleaned from the filter base. 3. Coat the seal of the new element with clean diesel fuel.4. Install the filter by hand. When the seal contacts the base, tighten 3/4 turn more.There are rotation marks 90° apart on the filter. Use these as a guide for proper tightening.5. Start the engine and check for leaks. If the engine will not start, prime the fuel system.